Before carrying out any operation on the pump: make sure the installation is disconnected from the power supply.
Before installation, thoroughly rinse the coil and the condensates collection tank to remove any foreign bodies and metal particles.
Detection unit installation
The detection unit can be connected in 3 ways:
The detection unit is connected to the condensate evacuation tube outlet or directly to the tank outlet. The pump is connected to the detection unit by a 6 x 9mm tube.
The detection unit must be fixed horizontally on a support.
The detection unit can be connected either at the front or the rear. Supplied as standard: outlet at back. Blank the unused outlet with the plug supplied.
First commission
IMPORTANT
To ensure that the pumps function correctly in the future, ensure that when you first commission them (and after each maintenance operation) the pumps are properly primed. Check that the suction pipe (between the detection unit and the pump) and part of the discharge pipe are filled with water. You can use the priming squeezie bottle ACC 00401.
Failure to observe these rules can lead to poor results (tank overflow, high noise level, abnormal overheating etc.) which are both inconvenient for the end user and costly for the installer.
Operation
The pump operates when condensate s enter the detection unit. In this configuration, a 230 V / 8 A NC alarm contact is available.
Maintenance
Replace the tube PE 5002 at least every year and the pump head PE 5001 every two years or as required. (Remove the 4 screws, disconnect the connector and fit the new head).
